SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM20241500 TRXREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 26 (ELECTRONIC CONTROL MODULES (SERVICE INFORMATION) - 1500 CLASSIC)MODULE, BODY CONTROL (BCM)INSTALLATION
2024 Dodge and Ram 1500 TRX

Module, Body Control (BCM): Installation

2024 Dodge and Ram 1500 TRXSECTION Installation
WARNING: This page is about a different car, the 2023 RAM 1500 Classic. However, it is still accessible from the selected car via links, so may be relevant.
GC0154493Courtesy of CHRYSLER GROUP, LLC
  1. Position the BCM (2) and install the two lower and upper BCM bolts (3) to retain the BCM to the BCM bracket (1).
  2. Install the left side instrument panel speaker. Refer to SPEAKER, INSTALLATION .
    GC0154501Courtesy of CHRYSLER GROUP, LLC
  3. Connect all wiring harnesses to the BCM (5).
  4. Position the park brake assembly back into place for installation. Refer to PEDAL, PARKING BRAKE, INSTALLATION .
  5. Connect the park brake switch connector.
  6. Install the left sill and cowl panel. Refer to PANEL, COWL TRIM, INSTALLATION .
  7. Install the remote park release access panel.
  8. Install the amplifier. Refer to AMPLIFIER, INSTALLATION .
  9. Connect the negative battery cable.
  10. Review the RF-HUB, BCM, PCM, FOBiK and ELV REPLACEMENT AND PROGRAMMING ORDER GUIDE. Refer to RF-HUB, PCM AND BCM REPLACEMENT AND PROGRAMMING ORDER GUIDE .
  11. Perform the Body verification Test. Refer to BODY VERIFICATION TEST .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.