SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM20241500 TRXREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 224 (POWER DISTRIBUTION - 1500)MODULE, WIRELESS CHARGING PADREMOVAL AND INSTALLATIONWIRELESS CHARGING PAD MODULE-TRX
2024 Dodge and Ram 1500 TRX

Wireless Charging Pad Module-TRX

2024 Dodge and Ram 1500 TRXSECTION Wireless Charging Pad Module-TRX
WARNING: This page is about a different car, the 2023 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

REMOVAL 

  1. Remove the shifter bezel. Refer to BEZEL, SHIFTER, REMOVAL AND INSTALLATION .
    GC0199190Courtesy of CHRYSLER GROUP, LLC
  2. Remove the fasteners (1) and lift the front storage bin (2) from the floor console (3) enough to gain access to the wire harness connectors.
  3. Disconnect the wire harness connectors and remove the bin (2) from the floor console (3).
    GC0186000Courtesy of CHRYSLER GROUP, LLC
  4. Remove the fasteners (1) securing the wireless charging pad module and remove wireless charging pad module from the front storage bin.

INSTALLATION 

GC0186000Courtesy of CHRYSLER GROUP, LLC
  1. Position the wireless charging pad module to the front storage bin, then install the fasteners (1) and tighten securely.
    GC0199190Courtesy of CHRYSLER GROUP, LLC
  2. Position the front storage bin (2) to the floor console (3) and connect the wire harness connectors.
  3. Install the front storage bin (2) to the floor console (3).
  4. Install the fasteners (1) and tighten securely.
  5. Install the shifter bezel. Refer to BEZEL, SHIFTER, REMOVAL AND INSTALLATION .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.