Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
KEYFOB Transmitter: Notes
2024 Dodge and Ram 1500 TRXSECTION Notes
WARNING: This page is about a different car, the 2023 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
Use a Radio Frequency Detector such as special tool (special tool #9001, Rf Detector) to confirm that the Remote Keyless Entry (RKE) transmitter is functioning. Typical testing distance is 30.5 centimeters (12 inches).
- Position the transmitter the appropriate distance from the special tool.
- Depress any transmitter button, then test each button individually. The special tool will issue an audible beep tone if a satisfactory radio signal strength that lights five or more Light Emitting Diode (LED) units is detected.
- Repeat Step 2 three times. If the transmitter fails any of the signal strength tests, use a diagnostic scan tool and the appropriate diagnostic information to complete further diagnosis.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.