Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSDODGE AND RAM20241500 TRXREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 198 (ELECTRONIC CONTROL MODULES (SERVICE INFORMATION) - 1500 (1 OF 2))MODULE, DISPLAY SCREEN (DSM)REMOVAL AND INSTALLATION8.4 INCH DISPLAY

2024 Dodge and Ram 1500 TRX

8.4 Inch Display

2024 Dodge and Ram 1500 TRXSECTION 8.4 Inch Display

WARNING: This page is about a different car, the 2023 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

REMOVAL

Disconnect and isolate the negative battery cable(s). Refer to BATTERY DISCONNECT AND CONNECT - SINGLE 12V BATTERY SYSTEM, 3.0L & 5.7L EZH or BATTERY DISCONNECT AND CONNECT - ETORQUE SYSTEM, 3.6L & 5.7L EZL or BATTERY DISCONNECT AND CONNECT - SINGLE 12V BATTERY SYSTEM, 6.2L .
Remove the instrument panel center bezel. Refer to BEZEL, INSTRUMENT PANEL, CENTER, REMOVAL AND INSTALLATION .

Courtesy of CHRYSLER GROUP, LLC
Remove the fasteners (1) and remove the Display Screen Module (DSM) (2) from the vehicle.

INSTALLATION

Position the DSM, then install and tighten the fasteners securely.
Install the instrument panel center bezel. Refer to BEZEL, INSTRUMENT PANEL, CENTER, REMOVAL AND INSTALLATION .
Connect the negative battery cable(s). Refer to BATTERY DISCONNECT AND CONNECT - SINGLE 12V BATTERY SYSTEM, 3.0L & 5.7L EZH or BATTERY DISCONNECT AND CONNECT - ETORQUE SYSTEM, 3.6L & 5.7L EZL or BATTERY DISCONNECT AND CONNECT - SINGLE 12V BATTERY SYSTEM, 6.2L .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.