SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM20241500 TRXREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESELECTRONIC CONTROL MODULES (SERVICE INFORMATION) - 1500 (1 OF 2)MODULE, CENTRAL VISION PROCESSING (CVPM)MODULE PROGRAMMINGCVPM PROGRAMMING
2024 Dodge and Ram 1500 TRX

CVPM Programming

2024 Dodge and Ram 1500 TRXSECTION CVPM Programming

The Central Vision Processing Module (CVPM) will need to be programmed when service is performed on any of the Surround View Cameras (SVCs) or the CVPM itself. The calibration routine is located in the "Surround View Camera" selection. Navigate to the "Misc. Functions" tab and select the "CVPM Service Calibration" routine to begin the calibration process.

NOTE: To run this routine, all exterior mirrors must be fully extended and all of the doors must be closed. The vehicle will need to be driven between 5 and 8 kilometers/hour (km/h) / 3 and 5 miles per hour (mph) in a straight line. The SVC is looking for features such as paint lines, other vehicles or other physical objects. It is recommended to perform the calibration in a parking lot environment.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.