Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023PROMASTER 3500 VAN CARGOREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCECHIME/BUZZER/DRIVER ASSIST (SERVICE INFORMATION)CAMERA, SURROUND VIEWREMOVALREAR
2023 Dodge and Ram ProMaster 3500 Van Cargo
Camera, Surround View: Removal: Rear
2023 Dodge and Ram ProMaster 3500 Van CargoSECTION Rear
- Disconnect and isolate the negative battery cable.
- Remove the Center High Mount Stop Lamp (CHMSL) housing. Refer to LAMP, CLEARANCE, REMOVAL
.
- Disconnect the wire harness connector (2).
- Remove the camera bracket (3) fasteners (1) and remove the camera and bracket from the center clearance lamp housing.
- Remove the fasteners (1) securing the camera (2) to the bracket.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.