Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023PROMASTER 3500 VAN CARGO EXTENDEDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXDTC INDEX (1 OF 2)MODULE, DISPLAY SCREEN (DSM)
2023 Dodge and Ram ProMaster 3500 Van Cargo Extended
Module, Display Screen (DSM)
2023 Dodge and Ram ProMaster 3500 Van Cargo ExtendedSECTION Module, Display Screen (DSM)
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| B142A-4B | ECU UNIT HIGH TEMPERATURE - OVER TEMPERATURE |
| B157E-00 | TOUCH SCREEN LOCKED - NO SUBTYPE INFORMATION |
| B157E-01 | TOUCH SCREEN LOCKED - GENERAL ELECTRICAL FAILURE |
| B210A-16 | SYSTEM VOLTAGE - CIRCUIT VOLTAGE BELOW THRESHOLD |
| B210A-17 | SYSTEM VOLTAGE - CIRCUIT VOLTAGE ABOVE THRESHOLD |
| B2206-00 | CURRENT VIN MISSING MISMATCH - NO SUBTYPE INFORMATION |
| B221E-00 | ECU INTERNAL ERROR - NO SUBTYPE INFORMATION |
| U0010-00 | BH CAN INTERIOR BUS - NO SUBTYPE INFORMATION |
| U0011-00 | BH CAN BUS OFF PERFORMANCE - NO SUBTYPE INFORMATION |
| U0140-87 | LOST COMMUNICATION WITH BODY CONTROL MODULE-MISSING MESSAGE |
| U0140-8F | LOST COMMUNICATION WITH BODY CONTROL MODULE - ERRATIC |
| U0151-00 | LOST COMMUNICATION WITH CLUSTER CCN - NO SUBTYPE INFORMATION |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.