Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Module, Keyless Ignition Node (Kin): Description
The Keyless Ignition Node (KIN) contains the customer interface for ignition switch activation in the form of a momentary switch. Pressing the Start/Stop button is the method of activation by the customer. The KIN is ncased and secured to the instrument panel. Fastener tabs built onto the housing of the KIN latch into a grooved lip on the inner side of the instrument panel to secure it.
The KIN:
- is used on the vehicles featuring "Keyless Go" system
- is a slave module to the Radio Frequency Hub (RF-Hub)
- is primarily an Input/Output (I/O) device (A Start/Stop button and ignition position indication)
- contains a Low Frequency (LF) coil and other electronics to authenticate a Finger Operated Button (FOB), in the event of default or a low FOB battery
The KIN (START) processes:
- press Start/Stop button once = Transitions to Accessory
- press Start/Stop button again = Transitions to Run
- press Start/Stop button again = Transitions to OFF
- press Start/Stop button once with the brake applied = Transition to Start
The KIN contains four Light Emitting Diodes (LEDs) indicators:
- OFF
- ACCESSORY (ACC)
- ON (On or Run)
- ENGINE Start/Stop (center button backlight)
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.