Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Module, Integrated Center Stack (ICSM): Installation
- Position the Integrated Center Stack (ICS) module (2) to the instrument panel and connect the wire harness connectors.
- Install the ICS module (2) to the instrument panel.
- Install the fasteners (1) that secure the ICS and tighten securely.
- Install the Display Screen Module (DSM). Refer to MODULE, DISPLAY SCREEN (DSM), INSTALLATION .
- Install the instrument panel trim panel. Refer to PANEL, INSTRUMENT PANEL TRIM, INSTALLATION .
- Initiate the Actuator Calibration function using a scan tool. Refer to HVAC PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE .
If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to determine if alignment of the PROXI configuration data into the new ECU is needed. If PROXI alignment is needed, follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under the Body Control Module (BCM) Miscellaneous Functions menu.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.