Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023PROMASTER 3500 CUTAWAYREPAIR AND DIAGNOSISRESTRAINTSRESTRAINTS CONTROL SYSTEMSRESTRAINTS (SERVICE INFORMATION)TECHNICAL SPECIFICATIONSTORQUE SPECIFICATIONS
2023 Dodge and Ram ProMaster 3500 Cutaway
Torque Specifications
2023 Dodge and Ram ProMaster 3500 CutawaySECTION Torque Specifications
TORQUE SPECIFICATIONS
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. | COMMENT |
|---|---|---|---|---|
| Clockspring Tension Clamp Screw | 5 | - | 44 | - |
| Front Impact Sensor Mounting Nut | 8 | - | 71 | - |
| Inertia Switch Fastening to Body | 4 | - | 35 | - |
| Occupant Restraint Controller Mounting Nuts | 9 | - | 80 | - |
| Passenger Airbag Mounting Screws | 8 | - | 71 | - |
| Seat Belt Turning Loop Height Adjuster Mounting Screws | 28 | 21 | - | - |
| Seat Belt Lower Anchor To B-Pillar Screw | 40 | 30 | - | - |
| Seat Airbag Mounting Nuts | 5 | - | 44 | - |
| Side Curtain Airbag Mounting Screws | 6 | - | 53 | - |
| Side Curtain Airbag A-Pillar Reinforcement Mounting Screws | 9 | - | 80 | - |
| Seat Belt Buckle Mounting Screw | 40 | 30 | - | - |
| Seat Belt Lower Anchor To Bench Seat Riser Frame Bracket Screw | 40 | 30 | - | - |
| Seat Belt Turning Loop To Height Adjuster Nut | 45 | 33 | - | - |
| Seat Belt Turning Loop To Bench Seat Back Frame Mounting Screw | 40 | 30 | - | - |
| Seat Belt Retractor To Bench Seat Riser Frame Bracket Mounting Screw | 40 | 30 | - | - |
| Seat Belt Retractor To B-Pillar Mounting Screw | 40 | 30 | - | - |
| Side Impact Sensor (B-Pillar) Mounting Nut | 8 | - | 71 | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.