Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023PROMASTER 3500 CUTAWAYREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE, CENTRAL VISION PROCESSING (CVPM)REMOVAL
2023 Dodge and Ram ProMaster 3500 Cutaway
Module, Central Vision Processing (CVPM): Removal
2023 Dodge and Ram ProMaster 3500 CutawaySECTION Removal
- Remove the lower glove box assembly. Refer to GLOVE BOX, INSTRUMENT PANEL, REMOVAL
.
- Disconnect the wire harness connectors from the CVPM.
- Disengage the tabs (2) and remove the CVPM and bracket assembly (1) from the vehicle.
- Remove the fasteners (1) securing the module (2) to the bracket.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.