Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023PROMASTER 3500 CUTAWAYREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCECHIME/BUZZER/DRIVER ASSIST (SERVICE INFORMATION)SENSOR, BLIND SPOTREMOVAL
2023 Dodge and Ram ProMaster 3500 Cutaway
Sensor, Blind Spot: Removal
2023 Dodge and Ram ProMaster 3500 CutawaySECTION Removal
- Disconnect and isolate the negative battery cable.
- Remove the rear tail lamp cluster. Refer to LAMP, TAIL, REMOVAL .
- Remove the side element from the rear bumper.
- Pull the side element out in order to access and disconnect the wire harness connector (1).
- Remove the retainers (1).
- Pry off the blind spot sensor (2a) extracting it from the mount (2b) and releasing the retainers (2c).
- Remove the blind spot sensor (3).
- If necessary, disconnect the wire harness connector (1a) from the blind spot sensor (1b).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.