Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023PROMASTER 3500 CUTAWAYREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCE(FORWARD FACING CAMERA MODULE (FFCM) - ELECTRICAL DIAGNOSTICS)
2023 Dodge and Ram ProMaster 3500 Cutaway
(Forward Facing Camera Module (FFCM) - Electrical Diagnostics)
2023 Dodge and Ram ProMaster 3500 CutawaySECTION (Forward Facing Camera Module (FFCM) - Electrical Diagnostics)
- Diagnostic Code Index
- DTC Troubleshooting
- B1006-49-Half (Haptic Lane Feedback) - Internal Electronic Failure
- B1007-54-Half (Haptic Lane Feedback) - Missing Calibration
- B1EAB-00-Steering Wheel Cruise Control Switch - No Subtype Information
- B1EAB-86-Steering Wheel Cruise Control Switch - Signal Invalid
- B210A-00-System Voltage Low - No Subtype Information
- B210B-00-System Voltage High - No Subtype Information
- B2206-00-Current VIN Mismatch - No Subtype Information
- C0031-64-Left Front Wheel Speed Sensor - Signal Plausibility Failure
- C0034-64-Right Front Wheel Speed Sensor - Signal Plausibility Failure
- C0037-64-Left Rear Wheel Speed Sensor - Signal Plausibility Failure
- C003A-64-Right Rear Wheel Speed Sensor - Signal Plausibility Failure
- C003F-00-Wheel Speed Sensors Rotation Direction Correlation - No Subtype Information
- C0061-64-Lateral Acceleration Sensor - Signal Plausibility Failure
- C0062-64-Longitudinal Acceleration Sensor - Signal Plausibility Failure
- C0063-29-Yaw Rate Sensor - Signal Signal Invalid
- C0063-64-Yaw Rate Sensor - Signal Plausibility Failure
- C10F6-53-Brake Rolls Mode Active - Deactivated
- C1226-64-Brake Pedal Master Cylinder Pressure - Signal Plausibility Failure
- C1260-00-Abs/ESC Dynamic Controls Disabled - No Subtype Information
- C1407-86-Acknowledge Signal Fail From Brake System Module (BSM) - Signal Invalid
- C1409-97-Radar - Component Or System Operation Obstructed Or Blocked
- C140C-86-Half Intervention Request Time Out Of Range - Signal Invalid
- C1413-86-External Light Signal Fault - Signal Invalid
- C1415-53-Forward Collision Warning (FCW) Unavailable - Deactivated
- C1422-00-Internal HW Plausibility Check - No Subtype Information
- C1432-86-Turn Indicator Failure From Body Control Module (BCM) - Signal Invalid
- C1433-86-External Brake Signal Failure From Brake System Module (BSM) - Signal Invalid
- C1434-86-Brake Jerk Request Not Plausible - Signal Invalid
- C1436-86-Electric Parking Brake System Fail - Signal Invalid
- C1451-86-Acc (Adaptive Cruise Control) Safe - Signal Invalid
- C1453-86-Acc (Adaptive Cruise Control) Intervention Signals Not Plausible - Signal Invalid
- C14A5-92-Sensor Blinded - Performance Or Incorrect Operation
- C14A5-97-Sensor Blinded - Component Or System Operation Obstructed Or Blocked
- C14AA-64-Sensor Adjustment Required - Signal Plausibility Failure
- C1600-94-Supplier Mode Active - Unexpected Operation
- C2210-4B-Ecu OVERTEMPERATURE - Over Temperature
- P0780-68-Gear Shift Malfunction - Event Information
- P1C81-00-Shift Lever Position Indeterminate - No Subtype Information
- P1DCB-64-Reverse Gear Switch - Signal Plausibility Failure
- U0055-00-Can C2 Bus-No Subtype Information
- U0056-00-Can C2 Bus Off Performance-No Subtype Information
- U0100-00-Lost Communication With ECM - No Subtype Information
- U0121-00-Loss Of Communication With Brake System Module (BSM) - No Subtype Information
- U0131-00-Loss Of Communication With Electric Power Steering (EPS) - No Subtype Information
- U0140-00-Lost Communication With Body Control Module (BCM) - No Subtype Information
- U0151-87-Lost Communication With Occupant Restraint Controller (Orc) - Missing Message
- U0155-00-Loss Of Communication With Instrument Panel Cluster (IPC) - No Subtype Information
- U0159-00-Lost Communication With PAM - No Subtype Information
- U0401-00-Implausible Data Received From BSM (Brake System Module) - No Subtype Information
- U0418-64-Invalid Data Received From Brake System Module (BSM) - Signal Plausibility Failure
- U0420-64-Implausible Data Received From Electric Power Steering (EPS) - Signal Plausibility Failure
- U0422-64-Invalid Data Received From Body Control Module - Signal Plausibility Failure
- U1216-00-Lost Communication With Driver Assistance System Module - No Subtype Information
- U1216-87-Lost Communication With Driver Assistance System Module - Missing Message
- U1412-00-Implausible Vehicle Speed Signal Received - No Subtype Information
- U1415-00-Implausible/Missing Vehicle Configuration Data - No Subtype Information
- U1425-00-Implausible Pedal Position Signal Received - No Subtype Information
- U1464-64-Implausible Data Received From EPS Steering Torque - Signal Plausibility Failure
- U147A-00-Implausible Brake Pedal Position Signal Received - No Subtype Information
- U148A-64-Implausible Data Received From Driver Assistance System Module - Signal Plausibility Failure
- U148A-83-Implausible Data Received From Driver Assistance System Module - Value Of Signal Protection Calculation Incorrect
- U1518-00-Implausible Ambient Air Temperature Signal Received - No Subtype Information
- U1600-54-Ecu Application Software Mismatch - Missing Calibration
- U1930-86-Half (Haptic Lane Feedback) Operational Mode Status - Signal Invalid
- U1950-83-Implausible Data Received From Body Control Module (Can Message BCM_Command Integrity Error) - Value Of Signal Protection Calculation Incorrect
- U1952-61-Implausible Data Received From Brake System Module (Can Message Brake1 Integrity Error) - Signal Calculation Failure
- U1952-83-Implausible Data Received From Brake System Module (Can Message Brake1 Integrity Error) - Value Of Signal Protection Calculation Incorrect
- U1958-61-Implausible Data Received From Brake System Module (Can Message BSM_Yrs_Data Integrity Error) - Signal Calculation Failure
- U1958-83-Implausible Data Received From Brake System Module (Can Message BSM_Yrs_Data Integrity Error) - Value Of Signal Protection Calculation Incorrect
- U195E-83-Implausible Data Received From Electric Power Steering (Can Message EPS_Torque_OVERALAY Integrity Error) - Value Of Signal Protection Calculation Incorrect
- U1960-61-Implausible Data Received From ECM (Can Message Engine1 Integrity Error) - Signal Calculation Failure
- U1960-83-Implausible Data Received From ECM (Can Message Engine1 Integrity Error) - Value Of Signal Protection Calculation Incorrect
- U1966-61-Implausible Data Received From Electric Power Steering (Can Message GE Integrity Error) - Signal Calculation Failure
- U1966-83-Implausible Data Received From Electric Power Steering (Can Message GE Integrity Error) - Value Of Signal Protection Calculation Incorrect
- U1978-83-Implausible Data Received From Brake System Module (Can Message Status_EPB Integrity Error) - Value Of Signal Protection Calculation Incorrect
- U1982-83-Implausible Data Received From Brake System Module (Can Message Wheel_Info Integrity Error) - Value Of Signal Protection Calculation Incorrect
- U1984-83-Implausible Data Received From Brake System Module (Can Message Wheel_Speed Integrity Error) - Value Of Signal Protection Calculation Incorrect
- U1986-83-Implausible Data Received From Body Control Module (Can Message SCCM_CRS_CTRL Integrity Error) - Value Of Signal Protection Calculation Incorrect
- U198A-83-Implausible Data Received From Brake System Module (Can Message Brake7 Integrity Error) - Value Of Signal Protection Calculation Incorrect
- U19A4-64-Half (HAPTICAL Lane Feedback) Fail Safe Violation - Signal Plausibility Failure
- U19BD-83-Implausible Data Received From Body Control Module (Can Message SWSM_1 Integrity Error) - Value Of Signal Protection Calculation Incorrect
- U19BE-83-Implausible Data Received From Brake System Module (Can Message Brake18 Integrity Error) - Value Of Signal Protection Calculation Incorrect
- U19BF-83-Implausible Data Received From Brake System Module (Can Message Brake19 Integrity Error) - Value Of Signal Protection Calculation Incorrect
- U19C0-83-Implausible Data Received From Brake System Module (Can Message Brake17 Integrity Error) - Value Of Signal Protection Calculation Incorrect
- Standard Procedure
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.