Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023PROMASTER 2500REPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXDTC INDEX (1 OF 2)MODULE, FORWARD FACING CAMERA (FFCM)
2023 Dodge and Ram ProMaster 2500
Module, Forward Facing Camera (FFCM)
2023 Dodge and Ram ProMaster 2500SECTION Module, Forward Facing Camera (FFCM)
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| B1006-49 | HALF (HAPTIC LANE FEEDBACK) - INTERNAL ELECTRONIC FAILURE |
| B1007-54 | HALF (HAPTIC LANE FEEDBACK) - MISSING CALIBRATION |
| B1EAB-00 | STEERING WHEEL CRUISE CONTROL SWITCH - NO SUBTYPE INFORMATION |
| B1EAB-86 | STEERING WHEEL CRUISE CONTROL SWITCH - SIGNAL INVALID |
| B210A-00 | SYSTEM VOLTAGE LOW - NO SUBTYPE INFORMATION |
| B210B-00 | SYSTEM VOLTAGE HIGH - NO SUBTYPE INFORMATION |
| B2206-00 | CURRENT VIN MISMATCH - NO SUBTYPE INFORMATION |
| C0031-64 | LEFT FRONT WHEEL SPEED SENSOR - SIGNAL PLAUSIBILITY FAILURE |
| C0034-64 | RIGHT FRONT WHEEL SPEED SENSOR - SIGNAL PLAUSIBILITY FAILURE |
| C0037-64 | LEFT REAR WHEEL SPEED SENSOR - SIGNAL PLAUSIBILITY FAILURE |
| C003A-64 | RIGHT REAR WHEEL SPEED SENSOR - SIGNAL PLAUSIBILITY FAILURE |
| C003F-00 | WHEEL SPEED SENSORS ROTATION DIRECTION CORRELATION - NO SUBTYPE INFORMATION |
| C0061-64 | LATERAL ACCELERATION SENSOR - SIGNAL PLAUSIBILITY FAILURE |
| C0062-64 | LONGITUDINAL ACCELERATION SENSOR - SIGNAL PLAUSIBILITY FAILURE |
| C0063-29 | YAW RATE SENSOR - SIGNAL SIGNAL INVALID |
| C0063-64 | YAW RATE SENSOR - SIGNAL PLAUSIBILITY FAILURE |
| C10F6-53 | BRAKE ROLLS MODE ACTIVE - DEACTIVATED |
| C1226-64 | BRAKE PEDAL MASTER CYLINDER PRESSURE - SIGNAL PLAUSIBILITY FAILURE |
| C1260-00 | ABS/ESC DYNAMIC CONTROLS DISABLED - NO SUBTYPE INFORMATION |
| C1407-86 | ACKNOWLEDGE SIGNAL FAIL FROM BRAKE SYSTEM MODULE (BSM) - SIGNAL INVALID |
| C1409-97 | RADAR - COMPONENT OR SYSTEM OPERATION OBSTRUCTED OR BLOCKED |
| C140C-86 | HALF INTERVENTION REQUEST TIME OUT OF RANGE - SIGNAL INVALID |
| C1413-86 | EXTERNAL LIGHT SIGNAL FAULT - SIGNAL INVALID |
| C1415-53 | FORWARD COLLISION WARNING (FCW) UNAVAILABLE - DEACTIVATED |
| C1422-00 | INTERNAL HW PLAUSIBILITY CHECK - NO SUBTYPE INFORMATION |
| C1432-86 | TURN INDICATOR FAILURE FROM BODY CONTROL MODULE (BCM) - SIGNAL INVALID |
| C1433-86 | EXTERNAL BRAKE SIGNAL FAILURE FROM BRAKE SYSTEM MODULE (BSM) - SIGNAL INVALID |
| C1434-86 | BRAKE JERK REQUEST NOT PLAUSIBLE - SIGNAL INVALID |
| C1436-86 | ELECTRIC PARKING BRAKE SYSTEM FAIL - SIGNAL INVALID |
| C1451-86 | ACC (ADAPTIVE CRUISE CONTROL) SAFE - SIGNAL INVALID |
| C1453-86 | ACC (ADAPTIVE CRUISE CONTROL) INTERVENTION SIGNALS NOT PLAUSIBLE - SIGNAL INVALID |
| C14A5-92 | SENSOR BLINDED - PERFORMANCE OR INCORRECT OPERATION |
| C14A5-97 | SENSOR BLINDED - COMPONENT OR SYSTEM OPERATION OBSTRUCTED OR BLOCKED |
| C14AA-64 | SENSOR ADJUSTMENT REQUIRED - SIGNAL PLAUSIBILITY FAILURE |
| C1600-94 | SUPPLIER MODE ACTIVE - UNEXPECTED OPERATION |
| C2210-4B | ECU OVERTEMPERATURE - OVER TEMPERATURE |
| P0780-68 | GEAR SHIFT MALFUNCTION - EVENT INFORMATION |
| P1C81-00 | SHIFT LEVER POSITION INDETERMINATE - NO SUBTYPE INFORMATION |
| P1DCB-64 | REVERSE GEAR SWITCH - SIGNAL PLAUSIBILITY FAILURE |
| U0055-00 | CAN C2 BUS-NO SUBTYPE INFORMATION |
| U0056-00 | CAN C2 BUS OFF PERFORMANCE-NO SUBTYPE INFORMATION |
| U0100-00 | LOST COMMUNICATION WITH ECM - NO SUBTYPE INFORMATION |
| U0121-00 | LOSS OF COMMUNICATION WITH BRAKE SYSTEM MODULE (BSM) - NO SUBTYPE INFORMATION |
| U0131-00 | LOSS OF COMMUNICATION WITH ELECTRIC POWER STEERING (EPS) - NO SUBTYPE INFORMATION |
| U0140-00 | LOST COMMUNICATION WITH BODY CONTROL MODULE (BCM) - NO SUBTYPE INFORMATION |
| U0151-87 | LOST COMMUNICATION WITH OCCUPANT RESTRAINT CONTROLLER (ORC) - MISSING MESSAGE |
| U0155-00 | LOSS OF COMMUNICATION WITH INSTRUMENT PANEL CLUSTER (IPC) - NO SUBTYPE INFORMATION |
| U0159-00 | LOST COMMUNICATION WITH PAM - NO SUBTYPE INFORMATION |
| U0401-00 | IMPLAUSIBLE DATA RECEIVED FROM BSM (BRAKE SYSTEM MODULE) - NO SUBTYPE INFORMATION |
| U0418-64 | INVALID DATA RECEIVED FROM BRAKE SYSTEM MODULE (BSM) - SIGNAL PLAUSIBILITY FAILURE |
| U0420-64 | IMPLAUSIBLE DATA RECEIVED FROM ELECTRIC POWER STEERING (EPS) - SIGNAL PLAUSIBILITY FAILURE |
| U0422-64 | INVALID DATA RECEIVED FROM BODY CONTROL MODULE - SIGNAL PLAUSIBILITY FAILURE |
| U1216-00 | LOST COMMUNICATION WITH DRIVER ASSISTANCE SYSTEM MODULE - NO SUBTYPE INFORMATION |
| U1216-87 | LOST COMMUNICATION WITH DRIVER ASSISTANCE SYSTEM MODULE - MISSING MESSAGE |
| U1412-00 | IMPLAUSIBLE VEHICLE SPEED SIGNAL RECEIVED - NO SUBTYPE INFORMATION |
| U1415-00 | IMPLAUSIBLE/MISSING VEHICLE CONFIGURATION DATA - NO SUBTYPE INFORMATION |
| U1425-00 | IMPLAUSIBLE PEDAL POSITION SIGNAL RECEIVED - NO SUBTYPE INFORMATION |
| U1464-64 | IMPLAUSIBLE DATA RECEIVED FROM EPS STEERING TORQUE - SIGNAL PLAUSIBILITY FAILURE |
| U147A-00 | IMPLAUSIBLE BRAKE PEDAL POSITION SIGNAL RECEIVED - NO SUBTYPE INFORMATION |
| U148A-64 | IMPLAUSIBLE DATA RECEIVED FROM DRIVER ASSISTANCE SYSTEM MODULE - SIGNAL PLAUSIBILITY FAILURE |
| U148A-83 | IMPLAUSIBLE DATA RECEIVED FROM DRIVER ASSISTANCE SYSTEM MODULE - VALUE OF SIGNAL PROTECTION CALCULATION INCORRECT |
| U1518-00 | IMPLAUSIBLE AMBIENT AIR TEMPERATURE SIGNAL RECEIVED - NO SUBTYPE INFORMATION |
| U1600-54 | ECU APPLICATION SOFTWARE MISMATCH - MISSING CALIBRATION |
| U1930-86 | HALF (HAPTIC LANE FEEDBACK) OPERATIONAL MODE STATUS - SIGNAL INVALID |
| U1950-83 | IMPLAUSIBLE DATA RECEIVED FROM BODY CONTROL MODULE (CAN MESSAGE BCM_COMMAND INTEGRITY ERROR) - VALUE OF SIGNAL PROTECTION CALCULATION INCORRECT |
| U1952-61 | IMPLAUSIBLE DATA RECEIVED FROM BRAKE SYSTEM MODULE (CAN MESSAGE BRAKE1 INTEGRITY ERROR) - SIGNAL CALCULATION FAILURE |
| U1952-83 | IMPLAUSIBLE DATA RECEIVED FROM BRAKE SYSTEM MODULE (CAN MESSAGE BRAKE1 INTEGRITY ERROR) - VALUE OF SIGNAL PROTECTION CALCULATION INCORRECT |
| U1958-61 | IMPLAUSIBLE DATA RECEIVED FROM BRAKE SYSTEM MODULE (CAN MESSAGE BSM_YRS_DATA INTEGRITY ERROR) - SIGNAL CALCULATION FAILURE |
| U1958-83 | IMPLAUSIBLE DATA RECEIVED FROM BRAKE SYSTEM MODULE (CAN MESSAGE BSM_YRS_DATA INTEGRITY ERROR) - VALUE OF SIGNAL PROTECTION CALCULATION INCORRECT |
| U195E-83 | IMPLAUSIBLE DATA RECEIVED FROM ELECTRIC POWER STEERING (CAN MESSAGE EPS_TORQUE_OVERALAY INTEGRITY ERROR) - VALUE OF SIGNAL PROTECTION CALCULATION INCORRECT |
| U1960-61 | IMPLAUSIBLE DATA RECEIVED FROM ECM (CAN MESSAGE ENGINE1 INTEGRITY ERROR) - SIGNAL CALCULATION FAILURE |
| U1960-83 | IMPLAUSIBLE DATA RECEIVED FROM ECM (CAN MESSAGE ENGINE1 INTEGRITY ERROR) - VALUE OF SIGNAL PROTECTION CALCULATION INCORRECT |
| U1966-61 | IMPLAUSIBLE DATA RECEIVED FROM ELECTRIC POWER STEERING (CAN MESSAGE GE INTEGRITY ERROR) - SIGNAL CALCULATION FAILURE |
| U1966-83 | IMPLAUSIBLE DATA RECEIVED FROM ELECTRIC POWER STEERING (CAN MESSAGE GE INTEGRITY ERROR) - VALUE OF SIGNAL PROTECTION CALCULATION INCORRECT |
| U1978-83 | IMPLAUSIBLE DATA RECEIVED FROM BRAKE SYSTEM MODULE (CAN MESSAGE STATUS_EPB INTEGRITY ERROR) - VALUE OF SIGNAL PROTECTION CALCULATION INCORRECT |
| U1982-83 | IMPLAUSIBLE DATA RECEIVED FROM BRAKE SYSTEM MODULE (CAN MESSAGE WHEEL_INFO INTEGRITY ERROR) - VALUE OF SIGNAL PROTECTION CALCULATION INCORRECT |
| U1984-83 | IMPLAUSIBLE DATA RECEIVED FROM BRAKE SYSTEM MODULE (CAN MESSAGE WHEEL_SPEED INTEGRITY ERROR) - VALUE OF SIGNAL PROTECTION CALCULATION INCORRECT |
| U1986-83 | IMPLAUSIBLE DATA RECEIVED FROM BODY CONTROL MODULE (CAN MESSAGE SCCM_CRS_CTRL INTEGRITY ERROR) - VALUE OF SIGNAL PROTECTION CALCULATION INCORRECT |
| U198A-83 | IMPLAUSIBLE DATA RECEIVED FROM BRAKE SYSTEM MODULE (CAN MESSAGE BRAKE7 INTEGRITY ERROR) - VALUE OF SIGNAL PROTECTION CALCULATION INCORRECT |
| U19A4-64 | HALF (HAPTICAL LANE FEEDBACK) FAIL SAFE VIOLATION - SIGNAL PLAUSIBILITY FAILURE |
| U19BD-83 | IMPLAUSIBLE DATA RECEIVED FROM BODY CONTROL MODULE (CAN MESSAGE SWSM_1 INTEGRITY ERROR) - VALUE OF SIGNAL PROTECTION CALCULATION INCORRECT |
| U19BE-83 | IMPLAUSIBLE DATA RECEIVED FROM BRAKE SYSTEM MODULE (CAN MESSAGE BRAKE18 INTEGRITY ERROR) - VALUE OF SIGNAL PROTECTION CALCULATION INCORRECT |
| U19BF-83 | IMPLAUSIBLE DATA RECEIVED FROM BRAKE SYSTEM MODULE (CAN MESSAGE BRAKE19 INTEGRITY ERROR) - VALUE OF SIGNAL PROTECTION CALCULATION INCORRECT |
| U19C0-83 | IMPLAUSIBLE DATA RECEIVED FROM BRAKE SYSTEM MODULE (CAN MESSAGE BRAKE17 INTEGRITY ERROR) - VALUE OF SIGNAL PROTECTION CALCULATION INCORRECT |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.