Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
10 Inch Screen
2023 Dodge and Ram ProMaster 2500SECTION 10 Inch Screen
- Remove the fasteners (2) that secure the Display Screen Module (DSM) (1) to the DSM bracket.
- Pulling the DSM (1) gently by hand, release the upper retaining clips (3) and then lift up on the DSM (1) to disengage the lower posts from the DSM bracket.
- Disconnect the wire harness connectors from the DSM (1) and remove from vehicle.
- Using a trim stick or equivalent, release the center air outlets (1) and remove them from the vehicle.
- Remove the fasteners (1) that secure the DSM bracket (2) and remove the bracket from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.