Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
CVPM Programming
The Central Vision Processing Module (CVPM) will need to be programmed when service is performed on any of the Surround View Cameras (SVCs) or the CVPM itself. The calibration routine is located in the "Surround View Camera" selection. Navigate to the "Misc. Functions" tab and select the "CVPM Service Calibration" routine to begin the calibration process.
To run this routine, all exterior mirrors must be fully extended and all of the doors must be closed. The vehicle will need to be driven between 5 and 8 kilometers/hour (km/h) / 3 and 5 miles per hour (mph) in a straight line. The SVC is looking for features such as paint lines, other vehicles or other physical objects. It is recommended to perform the calibration in a parking lot environment.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.