Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Module, Vehicle System Interface (VSIM): Installation
2023 Dodge and Ram ProMaster 2500SECTION Installation
- Position the VSIM (1) to the cup holder support bracket (3).
- Engage the VSIM retaining tabs (2) to the cup holder support bracket.NOTE:
Verify the retaining tabs are fully engaged to the bracket.
- Position the cup holder support bracket (2) and connect the wire harness connectors.
- Install the fasteners (1) securing the cup holder support bracket to the instrument panel. Tighten the fasteners securely.
- Install the instrument panel cup holder. Refer to CUPHOLDER, INSTRUMENT PANEL, INSTALLATION .
- Connect the negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.