Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023PROMASTER 2500REPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCEELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE, POWERTRAIN CONTROL (PCM)REMOVAL
2023 Dodge and Ram ProMaster 2500
Module, Powertrain Control (Pcm): Removal
2023 Dodge and Ram ProMaster 2500SECTION Removal
- Disconnect and isolate the negative battery cable.
- Remove the cover protecting the PCM electrical connectors.
- Unlock and disconnect the wire harness connectors from the Powertrain Control Module (PCM) (1).
- Remove the fasteners (4).
- Remove the PCM from the bracket (2).
- If needed, remove the fasteners (3) that secure the bracket (2) and remove it from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.