Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Module Programming
2023 Dodge and Ram ProMaster 2500SECTION Module Programming
- Connect the diagnostic scan tool to the vehicle.
- Check the vehicle for any Diagnostic Trouble Codes (DTCs).
- Clear all stored DTCs.
- Turn the ignition OFF then back to ON and confirm that the DTCs are cleared.
- From the Vehicle View, Click on the BCM icon >> Misc. Functions >> and then perform the Proxi Configuration.
If required, continue to programming the next module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.