Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023PROMASTER 2500REPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCEELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE, BODY CONTROL (BCM)INSTALLATION
2023 Dodge and Ram ProMaster 2500
Module, Body Control (BCM): Installation
2023 Dodge and Ram ProMaster 2500SECTION Installation
- If separated, install the Body Control Module (BCM) to the BCM bracket.
- Position the (BCM) and bracket (1) to the instrument panel.
- Connect the wire harness connectors (2) to the backside of the BCM.
- Install the BCM and bracket (2) to the instrument panel.
- Install the fasteners (1) and tighten securely.
- Connect the wire harness connectors (1) to the front of the BCM (2).
- Install the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, INSTALLATION .
- Connect the battery cable to the negative battery terminal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.