Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Switch, Power Window: Description
A front door power switch module and bezel unit is located near the forward end of the armrest of each front door trim panel. Two different modules are used: a driver side module, and a passenger side module. Each switch button in both modules is identified with either an International Control and Display Symbol icon or text that clearly identifies the switch function, and each switch button has a Light Emitting Diode (LED) unit soldered to the switch circuit board that provides backlighting of the icon or text for night visibility.
Each switch module housing is secured within the trim panel armrest by spring clip retainers, two on each side of the switch module housing. A connector receptacle integral to the switch module housing connect the switches to the vehicle electrical system through dedicated take outs and connectors of the door wire harness.
The front door power switch modules include the following switches:
- Power Mirror Selector Switch (Driver Side Switch Only) - Three mirror selector switch buttons choose the power mirror to be adjusted, R (right), L (left) or a power fold position (both mirrors).
- Power Mirror Direction Control Switch (Driver Side Switch Only) - After a power mirror is selected, pressing down on one of the arrows on the momentary mirror direction switch will move the selected mirror in that direction for as long as it is held down until the limit of the mirror travel is reached.
- Power Folding Mirror Switch - A single toggle switch (3) exists for folding and unfolding the outside rearview mirror assembly.
- Sliding Door Release Switch - The power sliding door release switch (1) allows the driver to allow ease of access to the cargo area of the van.
- Power Window Switches - A single two-way, momentary power window switch with a push-to-open and a lift-to-close tab is provide for each passenger door window while the driver side switch module contains four of these power window switches, one switch dedicated to each door window.
The front door power switch modules cannot be adjusted or repaired. If damaged or ineffective, the entire driver side or passenger side front door switch module must be replaced as a unit.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.