Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023PROMASTER 1500REPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE, POWERTRAIN CONTROL (PCM)INSTALLATION
2023 Dodge and Ram ProMaster 1500
Module, Powertrain Control (Pcm): Installation
2023 Dodge and Ram ProMaster 1500SECTION Installation
- If removed install the PCM bracket (2) and tighten the fasteners (3) to 18 N.m (13 ft. lbs.).
- Position the Powertrain Control Module (PCM) (1) to the PCM bracket (2) and tighten the three nuts (4) to 8 N.m (71 in. lbs.).
- Connect and lock the wire harness connectors (1) to the PCM.
- Install the protective cover over the PCM electrical connectors.
- Connect the negative battery cable.NOTE:
If a new PCM is installed, it must be programed with the original Vehicle Identification Number (VIN) and mileage. If this is not done, a Diagnostic Trouble Code (DTC) may set.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.