Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Module, Integrated Center Stack (ICSM): Description
The Integrated Center Stack (ICS) switch pod bank (1) is located in the center stack area of the instrument panel below the A/C heater control. This switch pod contains the following push button switches:
- Electronic Stability Control (ESC) OFF Switch
- Hazard Warning Switch
- Central Lock/Unlock Switch
- Park Assist OFF Switch
- Lane Keep Assist OFF Switch
The switch housing and the push buttons are constructed of molded plastic. Each push button has a smooth finish and is clearly identified with the appropriate text or International Control and Display Symbol icon. The hazard warning switch push button latches, while the Heated Glass, Fog Lamp, ESC OFF and Central Lock/Unlock Switch switches feature momentary operation.
Four screws secure the switch to the back of the switch pod trim panel through integral mounting bosses that are molded into the switch pod trim panel. The back of the switch pod has an integral connector receptacle containing terminal pins that connect the switch to the vehicle electrical system through a dedicated take out and connector of the instrument panel wire harness.
The individual switches in the switch pod cannot be repaired and are not serviced separately. If any component within the switch pod is damaged or inoperative, the entire switch pod must be replaced.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.