Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023DURANGO SXT, RWDREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSPOWER WINDOWS (SERVICE INFORMATION)SWITCH, POWER WINDOWINSTALLATIONFRONT SWITCH MODULE
2023 Dodge and Ram Durango SXT, RWD
Front Switch Module
2023 Dodge and Ram Durango SXT, RWDSECTION Front Switch Module
- Position the front door switch module (1) close enough to the mounting hole in the armrest (2) and connect the wiring harness connector (3).
- Align the switch module to the armrest mounting hole.
- Using hand pressure, firmly press the switch module evenly into the mounting hole, until the switch spring steel retainers are fully engaged and the switch bezel is fully seated against the armrest.
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.