Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023DURANGO SXT, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 42 (6.2L - DTCS U0418 TO U1504)DTC TROUBLESHOOTINGU11DE-LOST SPEED CONTROL MESSAGEDIAGNOSTIC TEST
2023 Dodge and Ram Durango SXT, AWD
Diagnostic Test
2023 Dodge and Ram Durango SXT, AWDSECTION Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
- CHECK COMMUNICATION BETWEEN THE SCCM AND THE SPEED CONTROL SWITCH ASSEMBLY
- Turn the ignition on.
- With the scan tool, read DTCs in the SCCM.
Is the SCCM reporting any Speed Control Switch or a Loss of Communication fault with the Speed Control Switch Assembly?
Yes
- Refer to DIAGNOSTIC CODE INDEX and perform the appropriate diagnostic test.
- Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
No
- Go To 2
- CHECK FOR AN ACTIVE DTC
- Cycle the ignition off and back to on.
- With the scan tool, read active DTCs.
Is this DTC active?
Yes
- Go To 3
No
- Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .
- CHECK FOR OTHER COMMUNICATION DTCS PRESENT
- With the scan tool continue reading PCM DTCs.
Is the PCM reporting any other Lost Messages or Implausible Data DTCs?
Yes
- Replace the Powertrain Control Module in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL (PCM), REMOVAL .
- Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
No
- Wiggle test and check the connector at the SCCM for an intermittent loose connection. If the wiring and connector tests good, replace and program the Steering Column Control Module (SCCM) in accordance with the Service Information.
- Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
- With the scan tool continue reading PCM DTCs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.