Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023DURANGO SXT, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 4 (5.7L FUEL SYSTEM)FUEL INJECTION, GASVALVE, SHORT RUNNERREMOVALREMOVAL
2023 Dodge and Ram Durango SXT, AWD
Valve, Short Runner: Removal: Removal
2023 Dodge and Ram Durango SXT, AWDSECTION Removal
WARNING: This page is about a different variant/trim than selected.
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the intake manifold. Refer to MANIFOLD, INTAKE, REMOVAL
.
- Remove bolts (1) and the Short Runner Valve (SRV) actuator (2).
- Remove and discard the SRV actuator rubber O-ring seal (1).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.