Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023DURANGO SXT, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE, POWER LIFTGATE (PLGM)REMOVAL
2023 Dodge and Ram Durango SXT, AWD
Module, Power Liftgate (PLGM): Removal
2023 Dodge and Ram Durango SXT, AWDSECTION Removal
- Disconnect and isolate the battery negative cable.
- Move the quarter trim panel from the lower left inner D-pillar (1) far enough to access the Power LiftGate Module (PLGM) (2). Refer to PANEL, QUARTER TRIM, REMOVAL .
- Disconnect the wiring harness connectors (3) from the PLGM.
- Release the retainers at the PLGM housing and pull the top of the PLGM away from the lower left inner D-pillar.
- Disengage the retainers at the lower end of the PLGM housing from the slots in the lower left inner D-pillar.
- Remove the PLGM from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.