Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Test
DRIVETRAIN CONTROL MODULE (DTCM) VERIFICATION TEST
If the DTCM, Powertrain Control Module (PCM), or Body Control Module (BCM) was replaced, refer to the Service Information for proper programming and alignment procedures.
- Reinstall any removed components.
- Reconnect any disconnected electrical connectors.
- Be certain the battery is fully charged.
- With the scan tool, erase DTCs.
- Remove the scan tool from the Diagnostic Link Connector (DLC).
- Turn off all accessories.
- Turn the ignition off and close all doors. Wait 30 seconds.
- Operate the vehicle under the conditions that originally set the DTC or caused the symptom.
- With the scan tool, read DTCs.
Are any DTC(s) or symptoms present?
Yes
- Perform the related diagnostic procedure for the DTC(s) or symptom.
No
- Test complete. To operate the Transfer Case in all possible modes of operation, perform the TRANSFER CASE VERIFICATION TEST. Refer to TRANSFER CASE VERIFICATION TEST .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.