Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023DURANGO SXT PLUS, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE, ADAPTIVE CRUISE CONTROL (ACC)MODULE PROGRAMMINGGEN 5
2023 Dodge and Ram Durango SXT Plus, RWD
Gen 5
2023 Dodge and Ram Durango SXT Plus, RWDSECTION Gen 5
This procedure must be performed in the following cases:
- Removing / Installing the radar sensor.
- Warning light indicated the failure of the radar sensor Proximity.
- Rear axle adjustments.
- Removing / Installing the front end.
Confirm the tire pressures are proper before starting the calibration procedure.
- Connect the diagnostic scan tool to the vehicle.
- Navigate to the ACC module "ECU view".
- Select the "Misc Functions" menu.
- Select the "ACC DASM Drive Calibration" procedure and then comply with the instructions provided on the diagnostic scan tool.
NOTE:
A Wi-Fi Mobile Hot Spot router is required for this procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.