Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023DURANGO SRT 392 PLUSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCEELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE, KEYLESS IGNITION NODE (KIN)REMOVALLATE MODEL
2023 Dodge and Ram Durango SRT 392 Plus
Late Model
2023 Dodge and Ram Durango SRT 392 PlusSECTION Late Model
REMOVAL
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the right instrument panel trim panel. Refer to PANEL, INSTRUMENT PANEL TRIM, CENTER, REMOVAL
.
- Remove the fasteners (2) and release the Keyless Ignition Node (KIN) module bracket (3).
- Press the tabs that secure the KIN to the KIN bracket (3) to release the KIN.
- If replacing the KIN (2), release the tab (3) on each side of the KIN and remove the bezel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.