Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023DURANGO SRT 392 PLUSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSPOWER LIFTGATE MODULE (PLGM) - DTCS B1882-92 TO U0422-00DTC TROUBLESHOOTINGB1955-00 POWER LIFTGATE LATCH RELEASE OVERCURRENTPOSSIBLE CAUSES
2023 Dodge and Ram Durango SRT 392 Plus
Possible Causes
2023 Dodge and Ram Durango SRT 392 PlusSECTION Possible Causes
| Possible Causes |
|---|
| BINDING LIFTGATE |
| WEAK OR DETERIORATED LIFTGATE SEAL |
| LIFTGATE LATCH CINCH DRIVER CIRCUIT SHORTED TO VOLTAGE |
| LATCH SECONDARY POSITION SENSE CIRCUIT OPEN |
| LIFTGATE LATCH RELEASE CIRCUIT SHORTED TO VOLTAGE |
| LOGIC GROUND CIRCUIT OPEN |
| LIFTGATE AJAR SWITCH SENSE CIRCUIT OPEN |
| LATCH ASSEMBLY |
Always perform the PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE before proceeding. Refer to PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.