Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Module, Drivetrain Control (DTCM): Operation: Inputs/Outputs
2023 Dodge and Ram Durango R/T, RWDSECTION Inputs/Outputs
The following are inputs to the DTCM:
- Lateral Accelerometer
- Transfer Case Mode Sensor Signal
- 2 Direct Battery Feeds
- Ignition RUN Sense
- Sensor Grounds
- Module Grounds
- CAN C Bus
The following are outputs of the DTCM:
- 5V Sensor Supply
- Transfer Case Bi-directional Motor Control (A AND B)
- Switched B+ Solenoid Supply
- Transfer Case Motor Brake Control
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.