Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023DURANGO R/T, AWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTWARNING SYSTEMSCHIME/BUZZER/DRIVER ASSIST (SERVICE INFORMATION)MODULE, PARK ASSISTREMOVAL
2023 Dodge and Ram Durango R/T, AWD
Module, Park Assist: Removal
2023 Dodge and Ram Durango R/T, AWDSECTION Removal
- Disconnect and isolate the negative cable from the battery.
- Partially remove the trim far enough from the right quarter inner panel to access the Park Assist Module (PAM) (4) on the inside of the right lower D-pillar (2). Refer to PANEL, QUARTER TRIM, REMOVAL .
- Disconnect the wire harness connectors (3) from the PAM connector receptacle. Vehicles equipped with the front park assist option will have an additional connection to the PAM at this location, which must also be disconnected.
- Remove the fastener (1) that secures the mounting tab at the top of the PAM to the inner D-pillar.
- Lift the PAM upward far enough to disengage the mounting tabs at the bottom of the PAM from the slots in the inner D-pillar.
- Remove the PAM from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.