Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023DURANGO R/T PREMIUM, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE, FORWARD FACING CAMERA (FFCM)MODULE PROGRAMMING
2023 Dodge and Ram Durango R/T Premium, AWD
Module Programming
2023 Dodge and Ram Durango R/T Premium, AWDSECTION Module Programming
The Forward Facing Camera (FFC) calibration will need to be performed under the following conditions listed below:
- If the FFC and/or windshield has been removed or replaced.
- If the FFC module is removed from the bracket and then reinstalled.
- If the customer brings in a vehicle with Lane Departure Warning (LDW) system behavior concerns.
Perform the following steps to calibrate the FFC:
- Connect the diagnostic scan tool and start the vehicle.
- Navigate to the "Misc Functions" menu under the FFC and select the drive calibration routine.
- The screen will now prompt you to drive the vehicle for calibration. The vehicle needs to be driven at speeds of at least 40 km/h (25 mph) but no more than 119 km/h (74 mph) and in the straightest road condition possible. You need a lane with lines (dashed or solid) on both sides of the vehicle. This averages to roughly ten minutes of drive time, terrain permitting.
- After the camera learns the calibration, the scan tool FFC view will show calibrated.
- Service calibration Diagnostic Trouble Codes (DTC) should be in the stored status at this point.
- Erase the FFC DTCs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.