Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023DURANGO R/T PLUS, RWDREPAIR AND DIAGNOSISENGINE PERFORMANCEIGNITION SYSTEM (SERVICE INFORMATION)SOLENOID, VARIABLE VALVE TIMINGINSTALLATIONLEFT
2023 Dodge and Ram Durango R/T Plus, RWD
Solenoid, Variable Valve Timing: Installation: Left
2023 Dodge and Ram Durango R/T Plus, RWDSECTION Left
- Install the Variable Valve Timing (VVT) solenoid seals (1). The seals can be reused if not damaged.
- Refer to the markings made at disassembly and install the intake VVT solenoid (4) and the exhaust VVT solenoid (2) in their original locations.
- Install the VVT solenoid mounting bolts (3) and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS .
- Connect the wire harness connector (1) to the VVT solenoid.
- Install the air inlet hose (3) to the air cleaner body and the throttle body and tighten the clamps (1, 4).
- Connect the wire harness connector (2) to the Inlet Air Temperature (IAT) sensor.
- Connect the negative battery cable and tighten the bolt to the proper specification. Refer to TORQUE SPECIFICATIONS .
NOTE:
The Cam/Crank Variation Relearn procedure must be performed using the scan tool anytime there has been a repair/replacement made to a powertrain system, for example: flywheel, valvetrain, camshaft and/or crankshaft sensors or components.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.