Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023DURANGO R/T PLUS, RWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE, DRIVETRAIN CONTROL (DTCM)REMOVAL
2023 Dodge and Ram Durango R/T Plus, RWD
Module, Drivetrain Control (DTCM): Removal
2023 Dodge and Ram Durango R/T Plus, RWDSECTION Removal
- Position the left front seat to its full forward position.
- Disconnect and isolate the negative battery cable. Refer to CABLES, BATTERY, REMOVAL
.
- Remove the cover panel from the electronic module tub (4) to access the DTCM (3).
- Disconnect the wire harness connector from the DTCM.
- Release the integral latches that secures the DTCM to the mounting bracket and slide the DTCM upward.
- Remove the DTCM from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.