Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023DURANGO R/T PLUS, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE, INTEGRATED CENTER STACK (ICSM)INSTALLATION
2023 Dodge and Ram Durango R/T Plus, RWD
Module, Integrated Center Stack (ICSM): Installation
2023 Dodge and Ram Durango R/T Plus, RWDSECTION Installation
- Position the Integrated Center Stack (ICS) (1) to the instrument panel. Connect the wire harness connector.
- Install the ICS (1) into the instrument panel, hand tap to fully set the retaining clips.
- Install the ICS fasteners (1) and tighten securely.
- Install the passenger side Instrument Panel Center Trim Panel. Refer to PANEL, INSTRUMENT PANEL TRIM, CENTER, INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.