Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023DURANGO R/T PLUS, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCEELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE, KEYLESS IGNITION NODE (KIN)REMOVALPURSUIT MODEL
2023 Dodge and Ram Durango R/T Plus, RWD
Pursuit Model
2023 Dodge and Ram Durango R/T Plus, RWDSECTION Pursuit Model
REMOVAL
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the right instrument panel trim panel. Refer to PANEL, INSTRUMENT PANEL TRIM, CENTER, REMOVAL
.
- Remove the fasteners (2) and release the Keyless Ignition Node (KIN) module bracket (3) from the right trim panel (1).
- Press the tabs that secure the KIN (2) to the KIN bracket (3) and remove the KIN (2).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.