Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023DURANGO R/T PLUS, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 62 (8HP95 AUTOMATIC TRANSMISSION - DTCS P1D90-00 TO P1DD0-00)DTC TROUBLESHOOTINGP1DAA-00-TRANS TEMP UNDETERMINEDDIAGNOSTIC TEST
2023 Dodge and Ram Durango R/T Plus, AWD
Diagnostic Test
2023 Dodge and Ram Durango R/T Plus, AWDSECTION Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
CHECK FOR TRANSMISSION FLUID TEMPERATURE SENSOR DTCS
- With the scan tool, read Transmission Control Module (TCM) DTCs and record on the repair order.
Are any Transmission Temperature Sensor DTCs set?
Yes
- Repair Transmission Temperature Sensor DTCs. Refer to DIAGNOSTIC CODE INDEX .
- Perform the TRANSMISSION VERIFICATION TEST. Refer to TRANSMISSION VERIFICATION TEST .
No
- Using the schematics as a guide, check the Transmission Control Module (TCM) connector and all related in-line connector terminals for corrosion, damage, or pushed out terminals. Pay particular attention to the power and ground circuits. If no problems are found, replace and program the TCM in accordance with the Service Information. Refer to MODULE, TRANSMISSION CONTROL (TCM), REMOVAL .
- Perform the TRANSMISSION VERIFICATION TEST. Refer to TRANSMISSION VERIFICATION TEST .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.