Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023DURANGO R/T PLUS, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 4 (3.6L FUEL SYSTEM)FUEL INJECTION, GASTHROTTLE BODYREMOVAL3.6L
2023 Dodge and Ram Durango R/T Plus, AWD
Throttle Body: Removal: 3.6L
2023 Dodge and Ram Durango R/T Plus, AWDSECTION 3.6L
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Never have the ignition key in the ON position when checking the throttle body shaft for a binding condition. This may set DTCs.
- Disconnect and isolate the negative battery cable.
- Remove the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL
.
- Disconnect the throttle body wire harness connector (1) and disengage the wire harness clip (2) from the throttle body.
- Remove the four bolts (1) and the throttle body.
- Remove and discard the O-ring seal (1).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.