Pump, Engine Oil: Installation

2023 Dodge and Ram Durango R/T Plus, AWDSECTION Installation
WARNING: This page is about a different variant/trim than selected.
GC0209665Courtesy of CHRYSLER GROUP, LLC
  1. Gently push the oil pump (1) upwards and press firmly against the block. finger tighten all of the retaining bolts (2) to ensure that the pump is fixed in it's position.
    Fig 1: Engine Oil Pump Tightening Sequence
    GC0209517Courtesy of CHRYSLER GROUP, LLC
  2. Using the sequence shown, tighten the oil pump retaining bolts to the proper specification. Refer to TORQUE SPECIFICATIONSΒ  .
  3. Install the timing chain cover. Refer to COVER(S), ENGINE TIMING, INSTALLATIONΒ  .
  4. Install the oil pump pickup tube and oil pan. Refer to PAN, OIL, INSTALLATIONΒ  .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.