Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023DURANGO R/T PLUS, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 3 (6.2L ENGINE (SERVICE INFORMATION))LUBRICATIONDIAGNOSIS AND TESTINGCHECKING ENGINE OIL PRESSURE
2023 Dodge and Ram Durango R/T Plus, AWD
Checking Engine Oil Pressure
2023 Dodge and Ram Durango R/T Plus, AWDSECTION Checking Engine Oil Pressure
WARNING: This page is about a different variant/trim than selected.
- Remove oil pressure sending unit. Refer to SENSOR, OIL PRESSURE, REMOVAL .
- Install gauge assembly (special tool #C-3292A, Gauge, Pressure).
- Run engine until thermostat opens.
- Check oil pressure gauge:
- Curb Idle-25 kPa (4 psi) minimum amount of pressure to lubricate engine
- 1000 rpm-234 kPa (34 psi) for a VVT engine to activate VVT
- 3000 rpm-170 - 758 kPa (25 - 110 psi)
- If oil pressure is 0 at idle, shut off engine. Check for a clogged oil pick-up screen or a pressure relief valve stuck open.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.