Body, Air Cleaner: Installation

2023 Dodge and Ram Durango R/T Plus, AWDSECTION Installation
WARNING: This page is about a different variant/trim than selected.
  1. If removed, insert the air inlet tube onto the air cleaner housing and tighten the clamp to the proper specification. Refer to TORQUE SPECIFICATIONSΒ  .
    GC0180914Courtesy of CHRYSLER GROUP, LLC
  2. While sliding the air duct onto the throttle body, lower the air cleaner housing into position, while aligning the air cleaner housing grommets (1) on bottom of the housing.
    GC0180922Courtesy of CHRYSLER GROUP, LLC
  3. Position the air inlet tube retaining clamp (1) at the throttle body and tighten to the proper specification. Refer to TORQUE SPECIFICATIONSΒ  .
  4. Connect the make-up air hose (2) to the air inlet tube.
  5. Connect the Inlet Air Temperature (IAT) sensor wire harness connector (3).
  6. Verify that the air cleaner housing (4) is properly secured to the grommets.
  7. Connect the negative battery cable.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.