Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023DURANGO R/T PLUS, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCEELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE, BODY CONTROL (BCM)REMOVAL
2023 Dodge and Ram Durango R/T Plus, AWD
Module, Body Control (BCM): Removal
2023 Dodge and Ram Durango R/T Plus, AWDSECTION Removal
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the passenger side lower Instrument Panel (IP) closeout panel.
- Remove the passenger side lower kick panel. Refer to PANEL, COWL TRIM, SIDE, REMOVAL
.
- Disconnect all of the Body Control Module (BCM) connectors.
- Remove the lower BCM mounting bracket fasteners (2).
- Slide the BCM (1) downward until the BCM is released from the two interference tabs, located at the top of the BCM.
- Remove the BCM from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.