Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023DURANGO GT, RWDREPAIR AND DIAGNOSISSTEERINGSTEERING LINKAGESTEERING SYSTEMGEARINSTALLATION
2023 Dodge and Ram Durango GT, RWD
Steering System: Gear: Installation
2023 Dodge and Ram Durango GT, RWDSECTION Installation
CAUTION:
The Steering Column Control Module (SCCM) is centered to the vehicles steering system. Failure to keep the system and steering column module centered and locked/inhibited from rotating can result in SCCM damage.
- Position the steering gear (3) to the crossmember cradle.
- Install the two steering gear bolts (2) and tighten to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
- Install the one steering gear bolt (4) and tighten it to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
- Insert both outer tie rod end studs into the steering knuckles.
- Install the two outer tie rod end nuts (5) and tighten them to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
- Install the front differential. Refer to INSTALLATION .
- Install the engine cradle. Refer to CROSSMEMBER, CRADLE, ENGINE AND SUSPENSION, INSTALLATION .
- Perform a front wheel alignment. Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.