Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023DURANGO GT, RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 3 (6.2L ENGINE (SERVICE INFORMATION))AIR INTAKE SYSTEMAIR CLEANERREMOVAL
2023 Dodge and Ram Durango GT, RWD
Air Cleaner: Removal
2023 Dodge and Ram Durango GT, RWDSECTION Removal
WARNING: This page is about a different variant/trim than selected.
- Disconnect and isolate the negative battery cable.
- Remove the air cleaner housing cover retaining screws (4).
- Disconnect the Intake Air Temperature (IAT) sensor wire harness connector (3).
- Disconnect the make-up air hose (2).
- Loosen the clamp (1) and remove air cleaner housing cover and inlet tube assembly.
- Remove the air cleaner element (1) from the housing.
- Clean the inside of air cleaner housing before replacing element.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.