Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023DURANGO GT, RWDREPAIR AND DIAGNOSISELECTRICALCHARGING SYSTEMSCHARGING SYSTEM (SERVICE INFORMATION)GENERATORREMOVAL3.6L
2023 Dodge and Ram Durango GT, RWD
Charging System (Service Information): Generator: Removal: 3.6L
2023 Dodge and Ram Durango GT, RWDSECTION 3.6L
- Disconnect and isolate the negative battery cable
- Unplug the field circuit (3) from generator.
- Remove the B+ terminal nut (1) and wire (2).
- Remove the serpentine belt. Refer to BELT, SERPENTINE, REMOVAL .
- Remove the lower front generator mounting retainer (5).
- Remove the mounting retainers.
- Remove the generator from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.