Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Module, Electronic Limited Slip Differential (ELSD): Installation
2023 Dodge and Ram Durango GT, RWDSECTION Installation
- Place the Electronic Limited Slip Differential (ELSD) module onto the mounting bracket, making sure the bottom slides into the mounting bracket tabs (1).
- Install the ELSD module to mounting bracket bolt (1).
- Connect the wire harness connectors (2) to the ELSD module.
- Install the left quarter panel trim. Refer to PANEL, QUARTER TRIM, INSTALLATION .
- Connect the negative battery cable Refer to CABLES, BATTERY, INSTALLATION .
- Perform the Electronic Limited Slip Differential (ELSD) verification test. Refer to STANDARD PROCEDURE .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.