Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023DURANGO GT, RWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE, DOOR (DDM/PDM)REMOVAL
2023 Dodge and Ram Durango GT, RWD
Module, Door (DDM/PDM): Removal
2023 Dodge and Ram Durango GT, RWDSECTION Removal
- Disconnect and isolate the battery negative cable.
- Remove the lower trim panel from the inside of the front door. Refer to PANEL, DOOR TRIM, REMOVAL
.
- Disconnect each of the wire harness connectors from the door control module (2).
- Remove the fasteners (3) that secure the door control module to the front door hardware module carrier (1).
- Remove the door control module from the door hardware module carrier.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.