Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Module, Comfort Seat And Wheel (CSWM): Operation
The Comfort Seat Wheel Module (CSWM) is used to control the functions of the following systems:
- Vented Seats - Two vented seats can be controlled by the CSWM. Refer to OPERATION .
- Heated Seats - Up to four heated seats can be controlled by the CSWM. Refer to OPERATION .
- Heated Steering Wheel - The heated steering wheel is controlled by the CSWM. Refer to OPERATION .
The CSWM will configure itself depending on what components are installed on the vehicle. This allows for one module to be used for every component combinations available.
The CSWM will only be on with the engine running. Therefore the heated seats, vented seats, and heated steering wheel will only operate with the engine running. Seat heating and seat venting are independent systems; however, they can not be actuated at the same time. Turning the vented seats on when the heated seat are already on will turn off the heated seats and vice versa. The heated steering wheel on the other hand can be on at the same time as either the heated seats or the cooled seats.
The CSWM operates on fused battery current received from the ignition switch. The module is grounded to the body at all times through the electrical connector. Inputs to the module include Local Interface Network (LIN) data bus messages and standard hardwired 12 volt power and ground. In response to the LIN inputs the CSWM will control the battery current to the appropriate heated seat elements.
When a heated seat switch LIN data bus signal is received by the CSWM, the module energizes the selected heated seat element. The Low heat set point is about 38° C (100.4° F), and the High heat set point is about 42° C (107.6° F).
In addition to operating the heated seat elements, the CSWM sends Light Emitting Diode (LED) illumination messages to the Instrument Panel Cluster (IPC) via the LIN data bus. The IPC then sends the LED illumination message to the accessory switch bank so that the appropriate LEDs are illuminated for any given heating level. Pressing the switch once will select high-level heating. Pressing the switch a second time will select low-level heating. Pressing the switch a third time will shut the heating elements off.
If the CSWM detects a heated seat element OPEN or SHORT circuit, it will record and store the appropriate Diagnostic Trouble Code (DTC).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.